asapreta 9 Posted March 1 Share Posted March 1 My BigSur is installed Opencore, drivers e kexts, DSDT all updated and the boot hangs about 80% at the point shown in the pictures. I have to hard reset the computer a few times until it passes this point and after that the system runs smothly. The same computer ran Catalina without this issue. The System is a Gigabyte Z390 Gaming X, I5 9400f, RX580. Any hints? Link to post Share on other sites
Allan 5,545 Posted March 1 Share Posted March 1 Which method are you using to install BS? Link to post Share on other sites
asapreta 9 Posted March 1 Author Share Posted March 1 3 minutes ago, Allan said: Which method are you using to install BS? I booted and installed it from the image downloaded from Olarila website with the Z390 EFI folder replaced. Link to post Share on other sites
MaLd0n 6,579 Posted March 2 Share Posted March 2 use this folder https://tinyurl.com/ycr9g9ye disable csm if need Link to post Share on other sites
asapreta 9 Posted March 2 Author Share Posted March 2 6 hours ago, MaLd0n said: use this folder https://tinyurl.com/ycr9g9ye disable csm if need Thanks MaLd0n. I noticed it is a CLOVER bootloader instead of Opencore. Is there a reason to move to Clover in this case? And CSM is already disabled. Link to post Share on other sites
MaLd0n 6,579 Posted March 2 Share Posted March 2 Opencore https://tinyurl.com/y7puzwv9 Link to post Share on other sites
asapreta 9 Posted March 2 Author Share Posted March 2 42 minutes ago, MaLd0n said: Opencore https://tinyurl.com/y7puzwv9 Thank you. I have installed this (OC). It is better but still hangs a bit after. With the CLOVER one I have to try more but it didn't hang yet. Link to post Share on other sites
asapreta 9 Posted March 7 Author Share Posted March 7 On 3/2/2021 at 2:43 PM, MaLd0n said: csm is disabled? Yes it is. Link to post Share on other sites
Recommended Posts