Khid Posted February 9, 2008 Share Posted February 9, 2008 Been workin' on FCS2 in 10.4.9 on my Hack for quite a while now with no flaws, hitches, etc. Does it work with Leopard yet? Should I spend an entire weekend findin' out? I have the Install DVDS cause I purchased the Software, this helped me to avoid any issues with FCS2 in the first place when usin' 10.4.9. Anyone out there? Link to comment Share on other sites More sharing options...
nate256 Posted February 9, 2008 Share Posted February 9, 2008 yea it will work with leapord, if leapord works on you HAck. which im guessing it will if it works with tiger! you should be okay. you would only run into some minor problems if any. Link to comment Share on other sites More sharing options...
macintox Posted February 12, 2008 Share Posted February 12, 2008 Working fine here. No issues. Link to comment Share on other sites More sharing options...
tomazzzi Posted February 13, 2008 Share Posted February 13, 2008 work just like on my friend s mac pro Link to comment Share on other sites More sharing options...
iRed Posted February 13, 2008 Share Posted February 13, 2008 working as a beast Link to comment Share on other sites More sharing options...
revolutionbr Posted February 25, 2008 Share Posted February 25, 2008 What distro are you using for 10.4.9? Uphuck? Link to comment Share on other sites More sharing options...
filomur Posted March 26, 2008 Share Posted March 26, 2008 Worked on Leo 10.5.2 but slower and more unstable than Tiger(on hack). Reinstalled Tiger. Link to comment Share on other sites More sharing options...
ihtus Posted March 26, 2008 Share Posted March 26, 2008 Hey Khid! I`ve been folowing all the instructions on this forum for a 1 mounth but no luck to make FCP6 run on mz system. Dude...1 damn mounth. I just cannot figure it out what is wtong. I`ve installed FCS2, everything is working (motion,DVD studio,compressor etc) except Final cut. I have os x 10.4.9 uphuck, Intel pentium 4 (HT) 2 GB RAM, 250 GB SATA, Nvidia quadro FX500/600 (supprts QE, I cannot see rotation...) Gzgabite motherboard wth built-in ethernet(marvel yukon/working perfictly) set as en0, ....I did everzthing else that I found on the forum.....but it just not working. As I sad it`s been a mounth already, can you or someone HELP me please???? Thnx!!!!! Roz Link to comment Share on other sites More sharing options...
chavxxx Posted June 21, 2008 Share Posted June 21, 2008 my Kalyway 10.5.1 updated to 10.5.3 runs well with final cut. so far no problems Link to comment Share on other sites More sharing options...
Recommended Posts