asheenlevrai Posted September 11, 2020 Share Posted September 11, 2020 (edited) Hi I recently built my 1st ryzentosh. I also used Opencore (0.6.1) for the 1st time and followed the install guides on Dortania. Now I need to map my USB ports and apparently it's not achieved the same way on AMD platforms compared to what I was "used to" on Intel platforms. The guide on Dortania is a bit confusing to me since there is information that is not clearly labelled as "for Intel" or "for AMD" and I thus don't understand very well what I should and shouldn't do. Can anyone give me advice or point towards as comprehensive tutorial intended for AMD-based builds. Thank you very much in advance for your help. Best, -a- Edited September 13, 2020 by asheenlevrai Link to comment https://www.insanelymac.com/forum/topic/345103-usb-mapping-on-ryzentosh/ Share on other sites More sharing options...
AudioGod Posted December 26, 2020 Share Posted December 26, 2020 What’s your system spec? Link to comment https://www.insanelymac.com/forum/topic/345103-usb-mapping-on-ryzentosh/#findComment-2747690 Share on other sites More sharing options...
Avery B Posted December 26, 2020 Share Posted December 26, 2020 The USBMap utility from CorpNewt has pretty good support now for AMD - it should be pretty similar to Intel now. For my Ryzen system, I used the port limit patch in OC to make sure all my ports were in macOS, then started plugging stuff in and filling in the map w/ CorpNewt's utility. I wouldn't recommend leaving the port limit patch enabled long term though, just long enough to do your USB mapping. 1 Link to comment https://www.insanelymac.com/forum/topic/345103-usb-mapping-on-ryzentosh/#findComment-2747696 Share on other sites More sharing options...
Recommended Posts