Atomic_Sheep Posted February 26, 2018 Share Posted February 26, 2018 Hi, I'm installing High Sierra on my hackintosh. The comp is old, i7 930, Gigabyte X58A-UD3R and GTX260 with old school BIOS. I'm trying to install onto a RAID 1 Mirror x2HDD setup. I have successfully booted clover and then went to boot from bootable USB on which I have the HS installer and clover EFI. I have -v enabled but it goes too quick to be of any use, not sure how to pause it if it all possible. Basically, it starts running through lines of stuff and then it resets all of a sudden. After the reset, the USB is no longer recognised by the computer and I have to pull it out and put it back in, but I think this last point is largely irrelevant. Is there some way for me to pause the -v to see where the error occurs? Link to comment Share on other sites More sharing options...
artur_pt Posted February 26, 2018 Share Posted February 26, 2018 hello take a read here http://www.insanelymac.com/forum/topic/332126-guide-ga-x58a-ud3r-v2-10133-high-sierra/ good hack 1 Link to comment Share on other sites More sharing options...
Recommended Posts