New EL Capitan Install Please Give Me Some Knowledge after Install

[makk]

Thank you first of all for this forum!

 

After I successfully install El Capitan onto the SSD, what must I do to make sure my hardware doesn't {censored} out?

 

I installed El Capitan 10.11.1 or 0 and then proceeded to do the combo update upon restart, had a kernel panic and then reinstalled and did not update.

 

I downloaded Pandora to get some hardware to work but my lack of definition for the words, upon using the methods, Had to reinstall again. 

 

my ASUS K53E laptop does not have the UEFI for Mac booting but for Windows?  Because the USB bootable I used boots up using chameleon.  Even this bootable has the three methods installed on it, my system doesn't boot UEFI even the BIOs option is enabled.  The BIOS is very limited and supports AHCI Sata, Has the Intel Virtualization to run VMware which I used to install EL Capitan 10.11 and then directly updated to 10.11.6.

 

 

On my SSD drive I have El Capitan 10.11.1? The very first one.  I do have internet because I installed the ALX kext and

I had to install ApplePS2Controller kext and a snub kext? to get my keyboard to work upon installation. 

I do not have Audio, Wifi and something else. 

 

My system is

 

ASUS K53E

Core i3 2310 Sandybridge 2.1Ghz 2 core, 4 processors

Intel HM65 Chipset series 6/200 Sata

Realtek ALC269 not sure what version or revision

Atheros AR8151 Gigabit Ethernet

Intel Centrino N-1030 Wifi

 

Windows 10 Anniversary but no dual boot.  

 

My SSD drive is plugged in via USB port on a stand. Sata 2 and 3 ?  Samsung EVO 250GB 

 

I after install I used Clover but did not boot via clover.  I had to use the bootable USB to boot overtime.

I tried to install via Pandora Enoch Chameleon to boot from the SSD drive.  did not work.

 

 

I realize I cannot boot via UEFI and have to use Enoch Chameleon.  But I do not know which version works and what to do since I'm very new to Mac hardware lingo.  Learning bit by bit.  

 

I tried the quick and dirty but, I realize I need to start from basics which I'm finding here and there.  

 

I apologize for the long post,

 

Thank you

Stu

 

[artur_pt]

hello

 

take a read here

 

http://olarila.com/forum/viewtopic.php?f=28&t=1716

 

good hack

[makk]

Hello Artur

 

Thanks for your site.

 

I need help getting Audio and Sleep mode.

 

HDMI works but I haven't tried the audio side yet for HDMI. I have no files to test.

 

I have Enoch 2839 and El Capitan 10.11.6

 

I have gathered some files for you to look at if you could?

 

 

bdmseg and CPU GPU power states files.

 

I was not allowed to upload IORegister.ioreg file -- not permitted it seems.

 

Thanks in advance.

 

If you could.

 

 

bdmesg Makiko.rtf

CPU GPU Power States.rtf