Inepsa Posted January 28, 2008 Share Posted January 28, 2008 I am using Kalyway 10.5.1 install. I installed just fine and booted in with no problems. I have had it installed for a couple of days now. One morning I went to boot it up, and it just hangs at the apple screen with the gear rotating. I am using a Gigabyte P35 - DS3L board. I have a core 2 duo. Any Ideas would be welcomed. Link to comment https://www.insanelymac.com/forum/topic/84238-105-will-not-load-anymore/ Share on other sites More sharing options...
Deviant0ne Posted January 28, 2008 Share Posted January 28, 2008 We need more information. Have you installed any new kexts or hardware? What does it say when you boot in verbose mode? Link to comment https://www.insanelymac.com/forum/topic/84238-105-will-not-load-anymore/#findComment-597946 Share on other sites More sharing options...
Inepsa Posted January 28, 2008 Author Share Posted January 28, 2008 The only thing that I have installed is my sound drivers. I don't know how to boot into verbose mode. I still use the disk to boot due to a b0 error. I still get that error after setting my partition active. Link to comment https://www.insanelymac.com/forum/topic/84238-105-will-not-load-anymore/#findComment-597961 Share on other sites More sharing options...
TheTimster Posted January 28, 2008 Share Posted January 28, 2008 are you running vanilla? if you are, install pc-efi v8 and use that to boot your leo partition. then once you get that bootloader in, you'll be able to hit f8 and type in -v at the darwin prompt to find out whats going wrong. Link to comment https://www.insanelymac.com/forum/topic/84238-105-will-not-load-anymore/#findComment-598014 Share on other sites More sharing options...
Inepsa Posted January 28, 2008 Author Share Posted January 28, 2008 I think i am going to just move back to XP. I will just wait untill either the price of Macs goes down, or they release their operating system. Link to comment https://www.insanelymac.com/forum/topic/84238-105-will-not-load-anymore/#findComment-598085 Share on other sites More sharing options...
Deviant0ne Posted January 28, 2008 Share Posted January 28, 2008 Good luck. I don't think either of those options will happen in quite some time. To boot in verbose mode hit F8 when your DVD starts to boot, and you'll then be asked what boot flags you'd like to boot with. At that point type -v and report back here what the screen says. That way we can help you figure out what's happening based on what information verbose mode provides. Link to comment https://www.insanelymac.com/forum/topic/84238-105-will-not-load-anymore/#findComment-598285 Share on other sites More sharing options...
Recommended Posts