anonymous86 Posted February 26, 2007 Share Posted February 26, 2007 Hi there, I installed OSX86 on quite a lot of systems, but this one is giving me a headache. I have a 20GB HDD configured as master, and I installed Windoze XP on it. Then I have a 250GB HDD configured as slave, and installed MacOS X on it. Both Installations went without a hitch, but once I start the System up, and select MacOS X via the Windows Bootmenu (I used the Chain0 Method), I only get a "Chain boot error". I then tried to set the 250GB as master, and the 20GB as slave, but alas, only a blinking underscore. Any Ideas? Link to comment https://www.insanelymac.com/forum/topic/43668-dualboot-using-2-hdds-chain0/ Share on other sites More sharing options...
riktor Posted February 27, 2007 Share Posted February 27, 2007 (edited) You could try using Grub or Acronis as bootloader instead of windows, it works here though. Edited February 27, 2007 by riktor Link to comment https://www.insanelymac.com/forum/topic/43668-dualboot-using-2-hdds-chain0/#findComment-312332 Share on other sites More sharing options...
Recommended Posts