[HELP] Found "AppleNVMe Assert failed: ( 0 != data )" and "SMCSuperIO ssio: @ failed to detect supported SuperIO chip" during the installation of Ventura 13.6.1

[Michael Ren]

I am trying to install macOS Ventura 13.6.1 on a HP 800 G6 Mini PC. The hardware setup is as below:

 

CPU: i5-10600

iGPU: UHD 630

RAM: Crucial 32GB DDR4-3200MHz *1

Motherboard: HP EliteDesk 800 G6 Mini PC

SSD: SN850X *1

Wifi/Bluetooth: None

Ethernet: Realtek RTL8125B

OpenCore: OC 0.9.6

macOS: Ventura 13.6.1

 

Config.plist: config.plist

EFI layout:

 

I was stuck at the installation message "SMCSuperIO    ssio: @ failed to detect supported SuperIO chip". Also, "AppleNVMe Assert failed: ( 0 != data )" showed up earlier. A log screenshot is posted as below.

 

I did some research, and I thought this was caused by mismatched SSDTs. So, I tried to create the custom SSDTs by using SSDTTime. Unfortunately, same errors popped up again.

 

Appreciate any help.

Edited December 14, 2023 by Michael Ren
Add extra information

[Slice]

It looks like you have no supported graphics.

[Michael Ren]

6 hours ago, Slice said:

It looks like you have no supported graphics.

I do not have a dGPU installed, but I think the iGPU is fine.

[Slice]

But it is fine after some efforts. Did you do anything?