TimeShift Posted October 26, 2013 Share Posted October 26, 2013 Hello yall. As I was getting the CMOS reset problem I searched for the binary patch and used this one http://www.insanelymac.com/forum/topic/289798-applertc-patch-cmos-reset-after-sleepwake/ Strangely, after I rebooted my computer, it finishes booting (even leaves the verbose screen) but it stays in a screen showing the apple logo and the mouse cursor. I have alreary booted with the usb and copied the original applertc back but no luck. Hope you can help me with this. Thanks in advance! Link to comment Share on other sites More sharing options...
Alex009988 Posted October 26, 2013 Share Posted October 26, 2013 Try to boot with -f -v if you use Chameleon Link to comment Share on other sites More sharing options...
TimeShift Posted October 26, 2013 Author Share Posted October 26, 2013 Try to boot with -f -v if you use Chameleon Already tried with all of them including -x, it even passes the verbose screen. Link to comment Share on other sites More sharing options...
nyolc8 Posted October 26, 2013 Share Posted October 26, 2013 If the problems persist even after you put back the original AppleRTC, then I think the problem caused by something else, not by the applertc. Link to comment Share on other sites More sharing options...
TimeShift Posted October 26, 2013 Author Share Posted October 26, 2013 If the problems persist even after you put back the original AppleRTC, then I think the problem caused by something else, not by the applertc. But strangely it only started after I patched it, rebooted, put the computer to sleep, wake up and reboot (and the patch didnt work because it still loses my cmos config) Link to comment Share on other sites More sharing options...
TimeShift Posted October 27, 2013 Author Share Posted October 27, 2013 Well, as I didn't find a solution I had to re-install the system. Everything except this part of sleep working fine again. Link to comment Share on other sites More sharing options...
Recommended Posts