yioulas Posted August 21, 2009 Share Posted August 21, 2009 I have successfully installed Ideneb 10.5.8 lite edition on my Dell Inspiron 9300. Everything works perfectly but I got one problem with my network which is very irritating. My network justs stops responding. I am using the broadcom 440x driver included with ideneb. I surf flawlesly for about 40 minutes (sometimes it lasts longer) than and then it suddennly stops. I tried a lot of different options during the installation to find out what causes it but no luck yet. Something changes after a while that causes my broadcom to stop responding. I tried renewing, reconnecting the wire but nothing happens. When I restart it starts working again until it stops. Any ideas? Thanks Mario Link to comment https://www.insanelymac.com/forum/topic/180924-inspiron-9300-with-ideneb-1058-lite/ Share on other sites More sharing options...
Vitaly Litvak Posted September 21, 2009 Share Posted September 21, 2009 Same problem on my Dell Inspiron 9400. Nothing helps Link to comment https://www.insanelymac.com/forum/topic/180924-inspiron-9300-with-ideneb-1058-lite/#findComment-1274848 Share on other sites More sharing options...
.javi Posted February 17, 2010 Share Posted February 17, 2010 Hello, i got the inspiron 9300 but im wondering what settings did you guys accepted to make it run. For me the install goes fine, but it doesnt boot, no errors it just stay doing nothing. Thanks for replying, if i get a workaround ill post it. Link to comment https://www.insanelymac.com/forum/topic/180924-inspiron-9300-with-ideneb-1058-lite/#findComment-1411730 Share on other sites More sharing options...
Recommended Posts