bedo Posted October 4, 2008 Share Posted October 4, 2008 Hello I just downloaded the kalyway 10.5.2 and burned it on a DVD I checked that my processor can run OS X (supports SSE2) Booted DVD and tried to enter setup but the PC rebootes on its own before after typing a couple of lines, tried safe mode it loads for a while then also reboots before setup. Desktop Motherboard : Intel 875z Processor :Intel Pentium 4 HT 2.8 Ghz 512Kb cache RAM : 1GB HDD : Seagate 120GB IDE Graphics : Nvidia 6200 128Mb AGP any ideas? Link to comment Share on other sites More sharing options...
swankyfarmboy Posted October 4, 2008 Share Posted October 4, 2008 Is your DVD correctly patched? Link to comment Share on other sites More sharing options...
bedo Posted October 4, 2008 Author Share Posted October 4, 2008 I set it to boot from DVD it's a sony DVD writer Do you mean burn it correctly? i used nero 7 to burn Link to comment Share on other sites More sharing options...
bedo Posted October 4, 2008 Author Share Posted October 4, 2008 i also tried with the HDD reformatted (Fat32) it also fails at the same spot Did i miss a step?? i tried -x for safe mode but still fails any ideas?? Link to comment Share on other sites More sharing options...
Donw35 Posted October 4, 2008 Share Posted October 4, 2008 disabble your nic card or remove it and see what happens Link to comment Share on other sites More sharing options...
bedo Posted October 4, 2008 Author Share Posted October 4, 2008 NIC built in on MB, disabled it from bios. It fails at some spot any more ideas?? thanks Link to comment Share on other sites More sharing options...
Recommended Posts