Jump to content

trotz Intel core 2 duo wird mir ein Intel core 2 Solo ausgegeben...was habe ich falsch gemacht?


Bastischen
 Share

14 posts in this topic

Recommended Posts

Hallo,

Ich habe ein Problem meinem Prozessor.

Ich habe einen Core 2 Duo E4600 auf einem Intel DG31PR Board.

Wenn ich jetzt Meine Sysem Configuration anschaue stürtzt er ab.

Es muss irgendeine einstellung im Bios sein.

Könntet ihr mir weiterhelfen?

Die BIOS-Einstellung "Report CPU Features for Legacy OS" Gibt es bei mir leider nicht... oder ich kann sie nicht finden.

Vielen dank für eure Hilfe.

Basti

Link to comment
Share on other sites

Also ich schreib euch mal meine Bios einstllungen auf.

 

 

 

Seite Main:

 

Bios Version PRG3110H.86A.0047.2008.0227.1745

 

Prozessor Type: Intel Core 2 Duo

E4600 @ 2,40Ghz

Intel EM64T Capable

 

 

SW Singel Processor Mode Disabel

 

Processor Speed: 2400 MHz

System Bus Speed 800 MHz

System Memory Speed 800 MHz

 

 

so jetzt kommen nur die sprachen

 

Seite Advance

 

Boot Configuration

Numlock OFF

Cpu fan control Enabel

system fan control Enabel

Lowest fan speed Slow

Max CPUID Value LIMIT Disabel

Display Setup Promt On

 

Peripheral Configuration

Serial port Disabel

Audi Enabel

High Definition Front panel Audio Enabel

On-bord lan Enabel

 

Dann kommt noch

Drive Configuration

Floppy Control

und Event Log... aber damit wird es ja nichts zu tun haben

 

 

Viedeo Configuration

DVMT Mode DVMT

IGD DVMT Memory Maximum DVMT

PEG Negotiated width x16

Primary Viedeo Adapter EXT PCIE Graphics (PEG)

 

Dann kommt der Hardware Monitor

....

 

Chipset Configuration

Memory Configuration

....

PCI Express configuration

Compliance Test Pattern Enabel

 

Pci Latency Timer 32

High Precision timer Enabel

 

 

So das wars... irgendwie muss es ja daran liegen...

aber ich find den fehler nicht...

Link to comment
Share on other sites

Nicht "erkannt" heißt nicht das er nicht verwendet wird. Guck mal in der Aktivitätsanzeige wie viele Kerne gezeigt werden.

Probier mal eine andere AppleSMBIOS.kext aus, dann sollten beide Kerne gezeigt werden.

Link to comment
Share on other sites

Also ein Bios Updade habe ich schon gemacht... und ein handbch liegt nicht dabei...

Habe mir natürlich schon das englische durchgelesen... aber da steht jetzt auch nciht wirklich was drin.

Hab meiner meinng nach alles richtig eingestellt.

Link to comment
Share on other sites

 Share

×
×
  • Create New...