Allan Posted May 22, 2016 Share Posted May 22, 2016 Its blank? It was not to be so. Link to comment Share on other sites More sharing options...
Quinzie XO Posted May 22, 2016 Author Share Posted May 22, 2016 It was not to be so. So what now ? Link to comment Share on other sites More sharing options...
Allan Posted May 22, 2016 Share Posted May 22, 2016 Put the hack to sleep, and all the problems that you told me will happen again. Boot up your Hack, and run this command. Link to comment Share on other sites More sharing options...
Quinzie XO Posted May 22, 2016 Author Share Posted May 22, 2016 Still the same blank output: https://www.imageupload.co.uk/image/czPa I don't know if I'm doing it right. I put my pc to sleep. Now the fans spin down and led blinks. But then try wake up again, system beachballs.. Then i press reset on pc case and both up again, open terminal and run the command. Thats the output. Mind you, NVinject=True is set in clover. Link to comment Share on other sites More sharing options...
Allan Posted May 22, 2016 Share Posted May 22, 2016 HDMI Works for some reason, but i use VGA. it shows the right memory as well. If you use only HDMI + sleep all the things work fine? VGA is not used in real Macs, maybe this is your problem. Link to comment Share on other sites More sharing options...
Quinzie XO Posted May 22, 2016 Author Share Posted May 22, 2016 If you use only HDMI + sleep all the things work fine? VGA is not used in real Macs, maybe this is your problem. My monitor is VGA only, so Did use a HDMI to VGA converter, and uhm, till clover i can see display through HDMI, after boot "no signal" Hence i can't check sleep on HDMI. Maybe fix exists. Back to VGA, i can get back to desktop. I have a 750ti. VGA is what most people use because this card seems to output from that port. Volume is wonky again. same errors like before you cleaned it. Link to comment Share on other sites More sharing options...
Recommended Posts