CaptChadd Posted May 16, 2012 Share Posted May 16, 2012 I have now got Snow Leopard fully working on my main AMD machine with full sound, network, usb and hardware acceleration. My build is in my signature so if anyone would like to know how I did it with this build (Some bits were tricky, like the network card) then let me know and I will help where I can. Link to comment Share on other sites More sharing options...
Shaneee Posted May 17, 2012 Share Posted May 17, 2012 How did you get hardware acceleration to work? Link to comment Share on other sites More sharing options...
Archxiao Posted May 29, 2012 Share Posted May 29, 2012 I would like to know if you could help me out with kexts for Battery management? Link to comment Share on other sites More sharing options...
dadofender Posted June 5, 2012 Share Posted June 5, 2012 I've managed to start the installation, and select the disk, but I've got an error about support files and it told me to restart, then i've tried to set my ram to 4gb (maxmem=4096) but I get a double panic, while installing :/ Booted from Nawcom ModCD 3.3, using retail disk of Snow Leopard 10.6.3. PC in signature! let me know, thanks Link to comment Share on other sites More sharing options...
LightInDark Posted June 6, 2012 Share Posted June 6, 2012 Hey did you encounter a problem where programs/applications refused to run and crashed on boot after going to 10.6.8? I get it and not sure how to fix.. ): Link to comment Share on other sites More sharing options...
Recommended Posts