Leo4allv2 Disk boot record not found

[Captain Scarlet]

Hi

 

I have recently downloaded Leo4allv2 and burnt the image to a DVD using Nero. Unfortunately when I try to boot from it I simply get the message that the DVD contains no boot record and cannot be used to start the PC. I fired up windows and mounted the downloaded image using deamon tools. I was then able to browse the DVD using Explorer and it contained the following files:

 

Boot

Boot0

Boot1h

Boot1i

CDBoot

Chain0

Boot.cat

Boothelp.txt

 

Am I missing something in the burning process? I have read that the burning speed should be kept low and I recall that Nero only burnt at 1200, which should be ok?

 

Any help would be greatly appreciated.

 

Regards

 

Captain Scarlet

[eddie11c]

Ok two things. Did you check the MD5 checksum of the ISO to make sure it is not corrupted? Download UltraISO and burn at <4x. With UltraISO you can switch and see the HFS+ partition also, where in Windows and Nero you will only see those few files.

[Captain Scarlet]

Thanks for the response. As usual it's always the simple things...doh. Ran the checksum and of course it didn't match. Now downloading again.....

 

Thanks again for the tip.

 

CS

[zonker]

Where are you downloading from? I see a lot of posts about it but don't know where to find it to try it out.