Jump to content

Leopard-10.5.2-AMD-EFI-Rev2 Problems


dk30
 Share

3 posts in this topic

Recommended Posts

I just tried several times to install the Leopard-10.5.2-AMD-EFI-Rev2.iso. I went trough the process using the ka911 guide. I made a single partition for the entire disk and I set the MBR option as indicated. Then in the custom section I made the choices to fit my system and added a bootloader for a single boot in the mbr. The installing process begun and it seemed that everything went fine, but at the reboot all I had was blank screen.

I checked with transmac and it seems that all the files are there. I think that the problem is in the mbr that is completely blank except for the partition table.

Is there something else that I could try?

Thanks.

 

Specs:

Asus a8r32 mvp

amd 4200+ 939

x1600xt

2 GB ram

Maxtor STM3320620A 300GB

Link to comment
Share on other sites

 Share

×
×
  • Create New...