Jump to content
1 post in this topic

Recommended Posts

When I install kalyway's 10.5.1 onto my computer i seem to get this error message over and over again. I have tried installing from inside VMWare with many different setups, all writing data to the actual harddrive and i get the same error every time. It will freeze after this point and force a restart.

 

Tried

-Changing the IDE order

-Booting into vanilla

-Booting native (no vmware) and i still get the same error message

-a different hard drive (gave me an b0 error, i wont even bother with that)

-legacy mode

-Easily 15 different VMWare configurations

 

Im kind of at a dead end at this point. I got JaS 10.4.7 to work a while back and thought about doing a clean install, but I lost my JaS disk so I decided to make the jump to leopard

 

Any help would be appreciated

 

Specs

 

E6600

DP965LT motherboard (Intel, latest BIOS)

2 GB DDR RAM 5300

500 GB Samsung HD (sata)

60 GB Maxtor (ide)

8800 GTS Video Card

BenQ DVD+_RW (ide)

USB Powered DVD RW (usb)

 

 

It would even be helpful if someone could post how they did this in VMWare to see if im overlooking something, or if someone has as similar setup and could tell me how they did it. Picture of the error below.

error.bmp

Link to comment
https://www.insanelymac.com/forum/topic/86474-installation-stalls/
Share on other sites

×
×
  • Create New...