Jump to content
3 posts in this topic

Recommended Posts

I am trying to dualboot between Windows XP (hda1)*, another XP (hdb2)*, OSX86 10.4.1 Dev (hdb3)*, and SuSE Linux 10.0 (hdb4)*.

All of the OS's can boot successfully except OSX86. I have the Windows bootloader by default and I have a GRUB floppy for linux. I was able to get the chainloader to run on the first Windows partition but it hangs for 2 hours and I give up. If I load the chain0 file off of my SuSE partition, it just reloads GRUB. Is there something I'm missing? I am trying this on an HP Pavilion 7955 and I do not want to touch the MBR.

 

--By the way, I am unable to change drives between master/slave due to the fact that I am doing this on a shared computer and I would like nothing to mess up with booting, etc.

 

*Drive names as shown in Linux.

 

Thanks in advance.

Link to comment
https://www.insanelymac.com/forum/topic/8516-dual-booting-osx-xp-and-linux/
Share on other sites

My chainloader file is on the root of hdb4. When I run the chainloader via GRUB, the screen just flashes black and GRUB reappears. I try to access the chainloader through the windows bootloader but for more than 2 hours, I was sitting in front of a blank, black screen with the HDD light on my pc on steadily. There was also the flashing _ in the top left corner of the screen. Is there a problem with using a slave drive for this install?

×
×
  • Create New...