ssj92 Posted December 27, 2007 Share Posted December 27, 2007 ok so i couldnt get leopard to boot after successful install so now no matter what each time i insert(with or without vanilla kernel) i get the message that i need to turn off power. what do i do now? heres a image of da power off message(my digital camera broke so had 2 get da image from a different thread): i even tried using the dell media direct cd to reformat the WHOLE hard drive and still get this message Link to comment https://www.insanelymac.com/forum/topic/78345-power-off-message/ Share on other sites More sharing options...
kaly Posted December 27, 2007 Share Posted December 27, 2007 boot with vebose mode ! at darwin boot loader type -v and you 'll see where kernel panic occur ! ttake a screen shot please ! Link to comment https://www.insanelymac.com/forum/topic/78345-power-off-message/#findComment-554583 Share on other sites More sharing options...
ssj92 Posted December 27, 2007 Author Share Posted December 27, 2007 boot with vebose mode ! at darwin boot loader type -v and you 'll see where kernel panic occur ! ttake a screen shot please ! ok sorry for the long time to reply but i went into the bios and turned the flash cache module off & set the hard drive mode from ahci to ata and now the leopard installer booted. just wondering two things: 1) should i use guid or mbr 2) should i use the vanilla kernel as well or not Link to comment https://www.insanelymac.com/forum/topic/78345-power-off-message/#findComment-554601 Share on other sites More sharing options...
Epo^_ Posted December 28, 2007 Share Posted December 28, 2007 I have this too. I only can boot in -x mode if I not I just get the restart screen. Link to comment https://www.insanelymac.com/forum/topic/78345-power-off-message/#findComment-555201 Share on other sites More sharing options...
Recommended Posts