ssj92 Posted December 27, 2007 Share Posted December 27, 2007 ok so i couldnt get leopard to boot after successful install so now no matter what each time i insert(with or without vanilla kernel) i get the message that i need to turn off power. what do i do now? heres a image of da power off message(my digital camera broke so had 2 get da image from a different thread): i even tried using the dell media direct cd to reformat the WHOLE hard drive and still get this message Link to comment Share on other sites More sharing options...
kaly Posted December 27, 2007 Share Posted December 27, 2007 boot with vebose mode ! at darwin boot loader type -v and you 'll see where kernel panic occur ! ttake a screen shot please ! Link to comment Share on other sites More sharing options...
ssj92 Posted December 27, 2007 Author Share Posted December 27, 2007 boot with vebose mode ! at darwin boot loader type -v and you 'll see where kernel panic occur ! ttake a screen shot please ! ok sorry for the long time to reply but i went into the bios and turned the flash cache module off & set the hard drive mode from ahci to ata and now the leopard installer booted. just wondering two things: 1) should i use guid or mbr 2) should i use the vanilla kernel as well or not Link to comment Share on other sites More sharing options...
Epo^_ Posted December 28, 2007 Share Posted December 28, 2007 I have this too. I only can boot in -x mode if I not I just get the restart screen. Link to comment Share on other sites More sharing options...
Recommended Posts