Jump to content

"Welcome screen" issue solved on my systems


3 posts in this topic

Recommended Posts

I don't know if it will help others but I solved the issue on my 3 computers in the following way:


1) enabled NIC card in BIOS (it is usually disabled on my systems since I have a wireless network)

2) at boot prompt I started using the following parameters: -x -v -f rd=disk0s1


Now it get through the Welcome screen and completes the installation.


Notice that I must use rd=disk0s1 because I still have the issue (I should say plague) of the left top blinking cursor. I have to leave my iatkos dvd into the drive and the I can boot from the hard drive. Don't know yet how to solve it.


Let me know if the above instructions are helpful for you as well. good night !

Link to comment
Share on other sites


  • Create New...