voxxdigital Posted November 7, 2007 Share Posted November 7, 2007 I have a perfectly working OSX86 install (10.4.10) but I need more space on the boot disk because of some software I need to install (must be on the boot drive). I already managed to clone my install but I needed to reformat the drive I used to clone the system and now I tried to clone again but there is no way in hell I can make it boot! I partitioned it as MBR, I manually set the partition as active, I cloned everything from the working drive (as I used to do), tried Carbon Copy Cloner and Super Duper, no dice. I even tried to make a new install of the system on the destination drive then clone my system over it, but it did't even boot from the fresh install in the first place. Both drives are connected to the ATA bus and are identical. Actually, connected to separate ATA busses, so both of them are set as master. The only difference is that the working drive is partitioned in two and I need to use the whole drive (hence the clone). Any thoughts? HELP! Link to comment https://www.insanelymac.com/forum/topic/70248-need-to-clone-osx86-install-help/ Share on other sites More sharing options...
foobarosx Posted November 8, 2007 Share Posted November 8, 2007 use acronis trueimage! put in the boot-cd (you can create it from the installed program - of course on windows) if any questions pm me ... :censored2: Link to comment https://www.insanelymac.com/forum/topic/70248-need-to-clone-osx86-install-help/#findComment-499262 Share on other sites More sharing options...
prototype_sx Posted November 9, 2007 Share Posted November 9, 2007 http://www.jasonmadigan.com/2007/11/04/bui...d-installation/ you can follow the booting instructions there Link to comment https://www.insanelymac.com/forum/topic/70248-need-to-clone-osx86-install-help/#findComment-500137 Share on other sites More sharing options...
Recommended Posts