digiplaya2005 Posted June 29, 2007 Share Posted June 29, 2007 Hi all! I've FINALLY (I won't do it in bold) got my blue computer setup to boot OSX through USB dvd burner and it detects my USB HD once it boots and in Disk Utility! However, the reason for this is because my VIA ATA Controller on my mobo (like many others) is not supported. I've taken my hard drive and put it inside a USB enclosure instead. I have a good feeling it will work perfectly but only under a certain way of doing things, ya know? Does anyone have any good steps for getting a Sis648/9xx north/south IDE to work well with bikedude880's driver? Because I know that you can edit the info.plist inside of it to change the IOPCIMatch variable or whatever that was to make it detect my IDE devices. But is that all? Most excited but not too optimistic quite yet, unixedout aka digiplaya Link to comment Share on other sites More sharing options...
digiplaya2005 Posted June 30, 2007 Author Share Posted June 30, 2007 UPDATE: For whatever reason, when I run Acronis software to examine the formally USB hard drive (now IDE), I see NO partitions listed! What's the cause behind this? The install went flawlessly, but no partition is shown after the install. Tom A. Link to comment Share on other sites More sharing options...
digiplaya2005 Posted July 1, 2007 Author Share Posted July 1, 2007 ** bump ** Cmon? Link to comment Share on other sites More sharing options...
Recommended Posts