redking Posted January 27, 2007 Share Posted January 27, 2007 I have created empty space on my drive, and created an af partition with diskpart in windows. I opened the installer and I got to the part about selecting a volume to install on, and there were no volumes in the list. I then went to the disk utility and was still unable to see my hard drive. From there I went to the system profiler, but found that my harddrive was not on the list. The drive is there, because I can boot into windows just fine. Any suggestions? Link to comment https://www.insanelymac.com/forum/topic/40163-installer-cannot-see-my-hard-drive/ Share on other sites More sharing options...
ninjapig Posted January 27, 2007 Share Posted January 27, 2007 I have created empty space on my drive, and created an af partition with diskpart in windows. I opened the installer and I got to the part about selecting a volume to install on, and there were no volumes in the list. I then went to the disk utility and was still unable to see my hard drive. From there I went to the system profiler, but found that my harddrive was not on the list. The drive is there, because I can boot into windows just fine. Any suggestions? you gotta at least tell us what your configuration is but i'm betting that you have a combination of a nforce and a sata hard drive you should look for my thread about that Link to comment https://www.insanelymac.com/forum/topic/40163-installer-cannot-see-my-hard-drive/#findComment-286611 Share on other sites More sharing options...
Recommended Posts