fspkwonx86 Posted October 30, 2025 Share Posted October 30, 2025 (edited) *Update but No Progress* here's what it didnt do: Authenticate the State of the Active Configuration: This is likely due to a bad flag, but the current code works: 7F020000. And it doesn't enable the loading of custom IOKit Kexts. Which was the whole point. But as far as System Integrity Protection it IS disabled. It takes this code to use Ammonia/Glow, without it, or going by any other suggestion it WILL NOT WORK. it shows me everything except the low low level stuff, and ai is telling me its because its all sandboxed .... and filtered.... to the USER it is to XNU it says its not.. and provides like a Kernel Extension Template for trying to log the verbs so that you can just look them up the same way as you would normally... Any suggestions? IOReg is reporting build ID as Tahoe Beta 1 , although it is 26.0.1 but w/e i just assume this means that you can use the Beta 1 KDK without any problems... Im currently writing a template from deepseek that hooks to get verbs. So I have a IOKit template Driver that logs all messages... and it unfortunately isn't loading it refuses to load when used with kmutil says loading requires a reboot.... so I should probably test using mykextinstaller I guess? Edited November 2, 2025 by fspkwonx86 Link to comment https://www.insanelymac.com/forum/topic/361897-macos-tahoe-seeking-help-getting-codec-verb-logs/ Share on other sites More sharing options...
Slice Posted November 8, 2025 Share Posted November 8, 2025 Try 870A0000 Link to comment https://www.insanelymac.com/forum/topic/361897-macos-tahoe-seeking-help-getting-codec-verb-logs/#findComment-2843421 Share on other sites More sharing options...
Recommended Posts