Jump to content

Help! my motherboard is dead.


4 posts in this topic

Recommended Posts

I will contact you because my motherboard ( Gigabyte H97) is dead.

I bought an Auros Elite AC Z490 (good idea? ...) and I cannot access my Mojave disk
New config:
Auros Elite AC Z490
CPU I5 10600K
GPU GT 740
RAM Corsaire Vengeance LPX DDR4 3200Mhz é x 8 gb
1 SSD Windows 10
1 SSD Mojave
1 SSD to install Catalina
I have recovered Windows 10 without problems.
I tried to boot Mojave with Clover and OC without result.
Without an OS X available, hard. I try with Windows but without result.
EFI to Boot Mojave or EFI to install Catalinaimage.gif.84e4c0bb385a64729c3495ca4b679d5b.gif
Can you help me?
Thank you and sorry for my poor English
 
2 hours ago, frapola said:
I will contact you because my motherboard ( Gigabyte H97) is dead.

I bought an Auros Elite AC Z490 (good idea? ...) and I cannot access my Mojave disk
New config:
Auros Elite AC Z490
CPU I5 10600K
GPU GT 740
RAM Corsaire Vengeance LPX DDR4 3200Mhz é x 8 gb
1 SSD Windows 10
1 SSD Mojave
1 SSD to install Catalina
I have recovered Windows 10 without problems.
I tried to boot Mojave with Clover and OC without result.
Without an OS X available, hard. I try with Windows but without result.
EFI to Boot Mojave or EFI to install Catalinaimage.gif.84e4c0bb385a64729c3495ca4b679d5b.gif
Can you help me?
Thank you and sorry for my poor English
 

Hi

1. Turn the p/c off and remove the power cable.

2. Press the power button to remove any static power from the capacitors.

3. Remove the CMOS Battery for approximately 2 minutes and then replace it.

4. Replace the CMOS Battery and power cable. 

5. Turn the p/c on and boot directly into the BIOS and load Optimize/Default BIOS settings and save.

6. Reboot back into the BIOS and change the settings from Optimize/Default BIOS settings to the ones to enable OS X, when done save and reboot.

Hopefully with the above steps your board will be back to operational use for both Windows and OS X. 

Good luck.

×
×
  • Create New...