shrm Posted November 12, 2006 Share Posted November 12, 2006 I successfully installed osx86. I then when to change the resolution by modifying the boot.plist file. I think I set my refresh rate too high (well, something went wrong) because when I boot up into OSX, the monitor doesn't display anything other than "No Input Signal" What do I do to fix this? Link to comment https://www.insanelymac.com/forum/topic/32957-resolution-problem/ Share on other sites More sharing options...
sadiekiller Posted November 12, 2006 Share Posted November 12, 2006 ahah umm, try again. re-install. I suppose you could use a VMware install that is linked to your drive and change back the bootfile, but that woudl take more time. Link to comment https://www.insanelymac.com/forum/topic/32957-resolution-problem/#findComment-232226 Share on other sites More sharing options...
Recommended Posts