Jump to content

How to setup Yosemite with XFX One Radeon HD 5450 1GB


Mr. Xtreme
 Share

6 posts in this topic

Recommended Posts

OK So I'll post my device ID once I restore the stock kexts :blush: .

So, I installed the graphics card which is a replacement for a GeForce GT 220 that had the fan bearings get dis-oriented,

Now I tryed adding my device ID to AMD5000Something kext and amdx3000something kext (The plist's in them that is) and now when I turn it on I get the yosemite loading screen then after     a few minutes it goes black with the spinning beachball, here are the specs of the Hack:

  • CPU:              Pentium G2030
  • Motherboard: GA-B75M-D3H
  • Video Card:   XFX One Radeon HD 5450 1GB
  • Ram:             1 x 4GB 1600GHz Kingston  DDR3
  • Hard Drive:   1TB WD 10EZEX
  • Case:            The Dead PowerMac G5 it replaced :D

       "Thats all folks" (To anyone who isn't in the USA/Canada that is a quote of what they say on Loony Tunes once the show is over).

       Thanks for your help.

Link to comment
Share on other sites

Here is a link to AMD5000Controller.kext and AMDRadeonX3000.kext and a txt/rtf with the device ID http://1drv.ms/1hth2TI .

Link to comment
Share on other sites

Maybe this threat will help you

I read that thread and is what I'm following only as René_ pointed out, I was just putting the right thing, in the wrong place.

Thanks Rene for the help.

 

 

AMDRadeonX3000.kext

You've put 0x68F91002 in section: <key>AMDBartsGraphicsAccelerator</key>
but it should be in section
<key>AMDCedarGraphicsAccelerator</key>

 

  • Like 1
Link to comment
Share on other sites

Got it sort of working but turns out the card was actually messed up so I returned it thanks for all the help would a mod please close this topic.

Link to comment
Share on other sites

 Share

×
×
  • Create New...