Marius_rg Posted October 1, 2015 Share Posted October 1, 2015 Hi, I'm having some weird issues with one of my El Captain installs. To keep it short, I have this setup bellow: - 2 HDDs, each one with their own OS X install; - today I installed EL Captain on one of the HDDs, that had Yosemite and made an upgrade (installed over) - once installed, started to configure clover and make everything work, like WIFI, sound, TRIM, NIC; - once all was good with clover and this setup, I went and did the upgrade on the primary HDD; - installed with success, booted with success first time (using same clover config from the second HDD); - rebooted a 2nd time and now I get kernel panic (same clover config) - I tried with also the other clover config, from main HDD, but get the same kernel panic. What did I broke, what can i do to resolve this issue (see attached the kernel error) Link to comment https://www.insanelymac.com/forum/topic/308292-kernel-panic/ Share on other sites More sharing options...
HBP Posted October 5, 2015 Share Posted October 5, 2015 check your clover config, make sure that if you have it modifying USB that you don't have it doing so in both locations (the DSDT block and the PCI devices block??) << been to long since I used Clover, but I do know that you can change USB from 2 locations in the boot options at boot time. try different settings then if it works go in and reset your plist to the new settings. HBP Link to comment https://www.insanelymac.com/forum/topic/308292-kernel-panic/#findComment-2173468 Share on other sites More sharing options...
Recommended Posts