cuzzo94 Posted December 10, 2013 Share Posted December 10, 2013 Hi all, i managed to make iAtkos ML2 work on my Asus x52jr. Almost everything works good, but not the external monitor.1- I have to switch between internal and exernal monitor in the bootloader, if i press fn-f8 after booting i just see stripes on both the screens, and i have to reboot2- if i switch to external monitor before boot it works good, but i have a problem with the resolution. In switchresx i actually have 1920*1080*57hz resolution (in current resolution tab), but if i set it something weird happens. It correctly sets the res, but it's "pressed" to assume 4/3 ratio, so everything is not sharp, it's unusable. I don't understand why this happens, because 1980x1080 is a 16/9 resolution o.O Moreover it works good with 1366*768 (the internal monitor resolution) and many other ones, but it's a waste on a 21.5" screen.The main problem is the second one, it's not a problem to switch screen before booting.Any ideas? Thank you all in advice. Link to comment https://www.insanelymac.com/forum/topic/294501-x52jr-external-monitor-resolution/ Share on other sites More sharing options...
iFIRE Posted December 10, 2013 Share Posted December 10, 2013 well, can be that you need patch the framebuffer to out video of your card, or try select other framebuffer Link to comment https://www.insanelymac.com/forum/topic/294501-x52jr-external-monitor-resolution/#findComment-1974917 Share on other sites More sharing options...
cuzzo94 Posted December 10, 2013 Author Share Posted December 10, 2013 well, can be that you need patch the framebuffer to out video of your card, or try select other framebuffer I tryed a lot of different framebuffers, but the situation only got worst. And i still have another problem. I can't boot without -f, i tryed removing and recreating kext cache but if i boot without -f flag i get kernel panic. EDIT:I remove the display override generated by switchresx, i removed the custom dsdl (copied from idk where) , i fixed the disk permissions and i ran some myHack utilities, and the situation got A LOT better. No need of -f at boot (it took ages to boot) and the resolution is close to the correct one. the situation is this, the image is still pressed and i have a little margin on the screen. https://dl.dropboxusercontent.com/u/18387650/IMAG1108.jpg Any ideas? Link to comment https://www.insanelymac.com/forum/topic/294501-x52jr-external-monitor-resolution/#findComment-1974947 Share on other sites More sharing options...
Recommended Posts