juragan Posted November 2, 2008 Share Posted November 2, 2008 I just got the distro few days ago and it is time for me to share a little experience to other on how to install the JaS 10.5.4 osx86 client/server distro. Its been a while since my last sucessful installation using Kalyway 10.5.1 distro and upgraded to 10.5.2. Tonite is going to be a very long nite, maybe. Hopefully the installation process will going smooth. Finally i got the welcome animated screen with sound. I did several try installation process. First thing to do is to go into the system profiler. Some of the information is kinda weird. - The System Profiler cant read my RAM profile - PCI card not detected (i have Wifi PCI card that was working fine in 10.4.8 and 10.5.2) - SATA Unknown AHCI Standard Controller - The Marvel Yukon network card not detected (driver installed) The rest is just fine. I might need to do a little work on this. Now im starting all over again. Erase all the partition and start to clean install. BTW, before going further I need to write down the BIOS setting and which SATA port that I connect my 500GB WDC Hard drive. - connect the HDD into the purple SATA - bios setting : Integrated Peripheral Set "Sata Port0-3 Native Mode" = Disabled Set "OnBoard SATA/IDE Device" = Enabled Set "OnBoard SATA/IDE Ctrl Mode" = AHCI As usual, boot from DVD-ROM. Press F8 boot: -v [enter] I make 3 partitions : 250 GB Main HD, 125 GB Storage 1, 125 GB Storage 2 Customize Install Option: - Kernel Package -> StageXNU - Chipset Driver -> Intel-ICHX - Audio -> AL888 - Video Card Driver -> NVkush - Device Identification -> Generic SATA Drive Icon Fix -> Intel ICH and PIIX Controller -> intel ICH8 and ICH9 Controller -> JMicron Controller - CleanUp Install run for about 10 minutes, restart. Before it goes into boot, I change the bios: - Integrated Peripheral Set "Sata Port0-3 Native Mode" = Disabled - Save & Exit Boot time ! Voila !! Link to comment Share on other sites More sharing options...
Recommended Posts