Nikola Tasic Posted May 5, 2008 Share Posted May 5, 2008 I was able to install Kalyway on Acer Aspire 5100 but was not able to boot it. Now I am searching for solution how to make it working. Link to comment https://www.insanelymac.com/forum/topic/289434-almost-but-still-not/ Share on other sites More sharing options...
Ztardust Posted December 7, 2008 Share Posted December 7, 2008 Hi there!I have an Acer Aspire 5100 working perfectly with OSX 10.5.5 including all the latest updates(it was a lot of work, though).Remove the natit kext, and you should be able to get the system up and going...How?Boot up in single user mode... to do that, you must type this when Darwin starts: -sThen when single user mode has loaded, you type the following(precisely like this):/sbin/mount -uw /cd /system/library/extensions/rm -r natit.kextrebootThen when Darwin comes up again, this you boot with these flags: -f -vThen I assume the system should start up correctly...Good luck,-Ztardust Link to comment https://www.insanelymac.com/forum/topic/289434-almost-but-still-not/#findComment-1922231 Share on other sites More sharing options...
Ztardust Posted December 7, 2008 Share Posted December 7, 2008 Ooops... just noticed your post is from may! I guess you have either figured this out, a long time ago, or given up... Link to comment https://www.insanelymac.com/forum/topic/289434-almost-but-still-not/#findComment-1922232 Share on other sites More sharing options...
Guest Guest: nikola_* Posted December 7, 2008 Share Posted December 7, 2008 Ectually I give up because I don't need OSX so much for my projects. And if I install it I will need to find software for OSX too so I will have double more data to collect . I hope I will buy one MacBookPro in next few years. Link to comment https://www.insanelymac.com/forum/topic/289434-almost-but-still-not/#findComment-1922233 Share on other sites More sharing options...
Recommended Posts