Jump to content

Change Icon in Acronis OS Selector


GBK.Xscape
 Share

3 posts in this topic

Recommended Posts

This has been discussed before. It is complicated because the entire selector is embedded in a compressed application which is decompressed each time it starts up. You have to find the exact point in the application where the icons are located, extract the compressed section, decompress it, change the icon, recompress it, place it back into the application without changing the number of bytes or its checksum will fail.

 

http://forum.insanelymac.com/index.php?showtopic=7654

Link to comment
Share on other sites

Not complicated with "Method 0" ( http://forum.insanelymac.com/index.php?s=&...st&p=128775 ), where you just have to run the application.

 

I have done a version that works with versions 9 and 10 up to the most recent version; might wait until another release to make sure it's ok with that one too. Right now only works with v.10.0.2117 (retail, not trial).

Link to comment
Share on other sites

 Share

×
×
  • Create New...