Jump to content
7 posts in this topic

Recommended Posts

For the past two days I have tried everything and I cant get OSX on my laptop.

 

Here's my system:

 

CPU Type QuadCore Intel Core i7-2720QM, 2200 MHz (22 x 100)

Motherboard Name Dell System XPS L702X

Motherboard Chipset Intel Cougar Point HM67, Intel Sandy Bridge

RAM 8GB

IDE Controller Intel® Mobile Express Chipset SATA AHCI Controller

Storage Controller MagicISO SCSI Host Controller

Disk Drive ST9500420AS (500 GB, 7200 RPM, SATA-II)

Optical Drive HL-DT-ST DVD+-RW GT32N

Optical Drive MagicISO Virtual DVD-ROM0000

SMART Hard Disks Status OK

 

 

BIOS Properties:

Vendor Dell Inc.

Version A10

Release Date 05/05/2011

Size 2560 KB

Boot Devices Floppy Disk, Hard Disk, CD-ROM, LS-120

Capabilities Flash BIOS, Shadow BIOS, Selectable Boot, EDD, BBS, Smart Battery

Supported Standards DMI, ACPI, ESCD, PnP

Expansion Capabilities PCI, USB

 

Yes I have the 10.6.3 retail dvd, I have tried it with [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] (legacy), nawcoms boot cd, pirateefix and bootthink. I have also tried several distros (i hate these but its a last resort) including iatkos v7, iatkos s3 v2, kalyway 10.5.2.

 

No matter what i do i get an error similar to this attachment

post-811181-1307825342_thumb.jpg

Link to comment
https://www.insanelymac.com/forum/topic/259019-desperate-for-snow-install-help/
Share on other sites

 

I have tried both the L502x guide and the L701x guide but neither of them address my issue. I know how to google, I have been searching the web for the past 3 days, either nobody has a similar problem or those who do have the same problem have not been answered.

Well search for ACPI error

 

e.g. First link of the search I gave you

6. Use [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] Legacy to boot and choose the select USB drive to install with the following options "-v -f GraphicsEnabler=No cpus=1 busratio=20" .

Well search for ACPI error

 

e.g. First link of the search I gave you

6. Use [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] Legacy to boot and choose the select USB drive to install with the following options "-v -f GraphicsEnabler=No cpus=1 busratio=20" .

 

I have done that. Like I said I know how to use google, I searched the web for days before I even posted here, the solution is not out there. What causes the acpi error is it the bios, the disc, the hd, other hardware?

×
×
  • Create New...