Kyle White Posted June 4, 2011 Share Posted June 4, 2011 I'm using the latest [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] and [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] 3.7. I can use [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] to load the installation, install, and initially boot OS X just fine. However, after installing 10.6.7 combo and then running [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] (DSDT, and Non-DSDT routines) results in the Boot logo coming up, and not actually loading anything upon boot. Going into -v mode will result in a blank, black screen. So, it doesn't seem to be doing anything.. If I boot the OS with [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] first, then I'm just fine, so I'm at a loss here. I'm using a GA-P67A-D3-B3 board, Core i5 with a 8800GT Kyle Link to comment https://www.insanelymac.com/forum/topic/258452-sitting-at-apple-logo-no-loading-spinner-after-multibeast/ Share on other sites More sharing options...
jtp.redson Posted June 8, 2011 Share Posted June 8, 2011 Kyle, Try booting in verbose mode from your bootloader and see what's the output. It will tell you where the system hangs and you can go on from there. Link to comment https://www.insanelymac.com/forum/topic/258452-sitting-at-apple-logo-no-loading-spinner-after-multibeast/#findComment-1694402 Share on other sites More sharing options...
Recommended Posts