Jump to content
5 posts in this topic

Recommended Posts

Hey folks,

 

I recently converted an old Inspiron 530.

I was initially happy about the install so the 1024x768 resolution did not bother me one bit but I have a 16:9 monitor that I would like to use with this setup. I searched and did not see a way to force a 16:9 resolution that worked on this system so I am looking for a video card.

 

The only thing is that I was hoping to get a video card that works out of the box because I don't want to risk any kernal errors since this system is all set up for my daily use and I don't want to lose everything and have to start all over.

 

Is there any video card be capable of this? Just pop it into the PCI-e slot and boot it up?

 

My understanding is that compatible Nvidia cards have the best chance. I see some Nvidia GeForce 7800 GT/GTX cards on eBay going for < $40. Would that be a good way to go?

 

Thanks in advance for any replies.

 

----------------------

 

System/Install info

I used iAtkos S3 V2 to get Snow Leopard on an old Inspiron 530. I eventually got it to work after choosing the right items under customization.

I then used the Apple 10.6.7 update to get it to 10.6.7.

 

The system does not have a video card and so I am using the on board video which was just listed as an Intel® G33/G31 Express Chipset Family under device manager before the install.

 

Dell Inspiron 530

Processor: 2.4GHz Intel Quad Core 2 Duo (Q6600)

RAM: 3GB

Video: On Board

 

 

Audio, networking, on board video all work. Sleep does not(I haven't bothered trying to fix this).

My only gripe with anything other than the video is that I have to go to system preferences --> VoodooHDA everytime I restart to lower the input gain due to the fact my speakers hiss if I don't. After restart, input gain always resets to a higher setting.

Yes, if you have a mpkg the it will install by itself but most likely it will be a kext just copy in S/L/E repair permissions shut down install new video card and reboot and it should work just fine

 

So I got a GeForce 7800 GT today. I installed NVenabler. Repaired permissions via disk utility. When I reboot, I get stuck at a blue screen. I can only launch back into via safe mode.

 

I did nothing else except install those kexts. Any idea what is happening?

 

EDIT: I logged in via safe mode. Removed the old kext. Downloaded it again from another source. This time I used Kext Utility to install NVenabler & NVinject. Rebooted. Works like a charm. Running on 1600x1050. Thanks!

×
×
  • Create New...