Jump to content
3 posts in this topic

Recommended Posts

Hi,

 

 

getting my hands wet with osx.

from reading about the DSDT file I understood that you have to tell OSX to use the DSDT.

 

so with [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] running in [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url], a DSDT will not be used by osx.

 

is that correct?

 

so if i extracted a DSDT, is it enough to copy the .aml to extras or do I need to tell OSX explicitly to use the DSDT.

does DSDT SE install take care of installing the dsdt into the boot process ? or do i need to run [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] with the DSDT option enabled ?

 

How can i verify if my DSDT is actually used during boot ?

 

 

cheers

bubba

Link to comment
https://www.insanelymac.com/forum/topic/250319-verify-if-dsdt-is-used-by-osx/
Share on other sites

as far as i know, when you extract your unmodified dsdt you will must do some changes before you can use it with osx

More precisely - it would be pointless to load an unmodified DSDT.

How can i verify if my DSDT is actually used during boot ?

Extract DSDT in OS X. If you get your modified DSDT, then it's loaded.

 

As Noam said, Chameleon will load DSDT.aml if it's in /Extra, you don't have to do anything.

  • Like 1
×
×
  • Create New...