MotoX Posted November 1, 2010 Share Posted November 1, 2010 My system runs fine with Leopard 10.5.6. I have decided to give MyHack a go and it will boot to the USB Flash Drive and install fine. After installing OSX86 I install Chameleon to the newly installed Mac installation and reboot, only to get the following: boot0: testing boot0: testing boot0: error I have gotten pretty far to figure out as to why I am getting this. The boot0 is successfully getting installed to the disk0. The boot1h is successfully getting installed to the disk0s1, however it gets wiped within about 10 seconds. I dd boot1h into disk0s1 and then check the first sectors of the partition and it is all there.....i wait about 10 seconds and then once again check the first sectors and it has been blanked out. Any ideas as to why Chameleon is getting wiped within 10 seconds of install? Thanks in advance. Link to comment Share on other sites More sharing options...
3.14r2 Posted November 1, 2010 Share Posted November 1, 2010 Chameleon is not installed or it is installed improperly. HOW-TO. Link to comment Share on other sites More sharing options...
Recommended Posts