Jump to content

[Help] iDeneb not start after installation


1 post in this topic

Recommended Posts

I tried to install iDeneb/W7 in dualboot


starting at the beginning...

I've created on w7 a second partition (33GB) with Disk Management tool

Then with the command diskpart (Run) I have activated the partition


Start the installation of iDeneb v1.5 10.5.7

In the customization i selected

bootloader: chameleon v2

kernel: none

ideneb x86 essential patches: appledecrypt, disabler, dsdt patcher, timemachine fix, openhaltrestart, ps/2 drivers voodoo, systemprofiler fix

fix: none

drivers: audio voodoohda, chipset ahci, network ethernet realtek rtk 8139


reboot after installation and appears the chameleon screen

( Darwin/x86 boot v5.0.132 - Chemeleon v2.0-RC2 r640

Built date: 2009-07-25 21:16:41

1023MB memory )

with the logo of windows and mac osx


w7 starts (although without transparency and aero peek)

mac osx blocks to initial screen with the apple (without any load)


I try to run in verbose mode but nothing doesn't happen and appears black screen

(also with -s -f appears black screen) and it doesn't go on


what up?? what must i do?? help me pls

tnk for all

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...