eds Posted July 29, 2006 Share Posted July 29, 2006 Hello everyone. I’m new to this great forum and was wondering if someone could help. I think I did everything right, but as stated in the thread, I can’t get the GoatsecxDVD installed. I burned it, loaded it, went to Disk Utility, created a partition for Windows XP and OSX. The Mac partition was Extended (journaling) the Windows was MS-Dos. Once partitions were created, I went to install (the Mac partition has a green arrow as if to say install here). The program tests the DVD, once done instillation begins. Both the percent complete and the length of time increase. Once completed (5-10 minutes tops), it displays the program has to be reinstalled (there were errors). The box is blank. When I hit restart, system freezes. That’s about it in a nutshell. My rig is custom built – 1 Maxtor Hard drive, Pentium D 805 (overclocked to 3.8 ghz, 2 gigs of ram (PQI DDR667), Powercolor Radeon ATX800GTO graphics card, Abit SLI NI8 motherboard. Any advice? Link to comment https://www.insanelymac.com/forum/topic/22907-install-fails-when-using-macosx1046-goatsecxdvd/ Share on other sites More sharing options...
Recommended Posts