Jump to content

Help! Boot Options to Install Hazard Snow Leopard 10.6.1-10.6.2


4 posts in this topic

Recommended Posts

I cannot boot up any version of Snow Leopard 10.6.X on my AMD Phenom 2 X4 955 64bit PC. I just dont know what the right combination of boot flags are.

 

I have enabled AHCI on Bios, and All other options are as default.

 

I installed iAtkos v7 successfully on the same PC, but that had different kernels that I could use to load up during installation. I used mach_970 busratio=20 for that one.

 

Can someone tell me what would work as the right boot flags for this PC? Configuration is below on my signature.

 

Thanks in Advance.

Link to comment
Share on other sites

I cannot boot up any version of Snow Leopard 10.6.X on my AMD Phenom 2 X4 955 64bit PC. I just dont know what the right combination of boot flags are.

 

I have enabled AHCI on Bios, and All other options are as default.

 

I installed iAtkos v7 successfully on the same PC, but that had different kernels that I could use to load up during installation. I used mach_970 busratio=20 for that one.

 

Can someone tell me what would work as the right boot flags for this PC? Configuration is below on my signature.

 

Thanks in Advance.

 

http://www.insanelymac.com/forum/index.php...amp;mode=linear

 

-v -x -F cpus=1 fsb=200000000

 

apply ppf

http://leohazard.com/update.html

Link to comment
Share on other sites

cpus=

busratio=

fsb=

maxmem=

-f

-v

-x

 

busratio=XX

 

XX=multiplier cpu

 

;)

 

example

 

3.2 GHz

 

3200 / 200=16

 

*busratio=16

 

or else

 

1 - see your multiplier through the CPUZ

 

2 - bios

Link to comment
Share on other sites

 Share

×
×
  • Create New...