grezman Posted January 6, 2010 Share Posted January 6, 2010 hello all. After successful installation of iDeneb i get the error "the hub it is attached to has been disabled". The board I use is MSI p965 Neo. Do you have any suggestions? Link to comment https://www.insanelymac.com/forum/topic/206010-ehci-root-hub-simulation-error%E2%80%8E/ Share on other sites More sharing options...
Rockystar Posted January 8, 2010 Share Posted January 8, 2010 hello all. After successful installation of iDeneb i get the error "the hub it is attached to has been disabled". The board I use is MSI p965 Neo. Do you have any suggestions? i was having the same problem and i researched it for hours yesterday. I found some sites that said i needed to change the iousbfamily.kext I found one made by slice that was for 10.5.8 replaced it and it seems to sorta fix the error. Now when i boot i get a very fast error pop up and i have no idea what it says. so i would say try this route and see what it does for you Link to comment https://www.insanelymac.com/forum/topic/206010-ehci-root-hub-simulation-error%E2%80%8E/#findComment-1380023 Share on other sites More sharing options...
Recommended Posts