Pentium 4 install help

[CrimsonAngel]

I'm trying to install OSX on an old computer with a Pentium 4 processor. Every time I tried installing the ideneb 1.5.1 the boot would hang at

 

appleintel8254XEthernet: Ethernet address then a bunch of numbers

 

I used the Acronis boot disc to wipe the hard drive and left it without a partition. When trying to install ideneb this time I get a kernel panic after 5 tries I use the ipc build kernel panic then I use leo4all 4.1 and it boots.

It is currently installing.

 

Well I finally got leo4all installed without any hitches with the speedstep 9.2.0 kernel when trying to update both the voodoo 9.5.0 kernel and the Anv 9.6.0 fail. I managed installing the Qoopz 9.7.0 kernel but I cant find a seatbelt kext to go with it (would they be any other kexts needed beside the seatbelt kext)

 

Then I tried updating to 10.5.7 with idenebs combo update, the system no longer booted I couldnt even get to the part where I would type code it simple went to a straight black screen when booted in verboose.

[OSx86NL]

I'm trying to install OSX on an old computer with a Pentium 4 processor. Every time I tried installing the ideneb 1.5.1 the boot would hang at

 

appleintel8254XEthernet: Ethernet address then a bunch of numbers

 

I used the Acronis boot disc to wipe the hard drive and left it without a partition. When trying to install ideneb this time I get a kernel panic after 5 tries I use the ipc build kernel panic then I use leo4all 4.1 and it boots.

It is currently installing.

 

Well I finally got leo4all installed without any hitches with the speedstep 9.2.0 kernel when trying to update both the voodoo 9.5.0 kernel and the Anv 9.6.0 fail. I managed installing the Qoopz 9.7.0 kernel but I cant find a seatbelt kext to go with it (would they be any other kexts needed beside the seatbelt kext)

 

Then I tried updating to 10.5.7 with idenebs combo update, the system no longer booted I couldnt even get to the part where I would type code it simple went to a straight black screen when booted in verboose.

 

iATKOS will install and run on your P4 system, but at the moment it's just good enough.

I've just install iATKOS on my p4, and these are the problems i'm facing:

1. Bootloader doesn't work, have to start OS X using the install disk and typing rd=disk0s1 (I think that could be, because P4 is SSE2 ONLY)

2. Drivers won't install. I've tried to install drivers for my hardware: It's just not working.