Jump to content

Success, Finally!


-jordn-
 Share

1 post in this topic

Recommended Posts

hey,

 

i finally got the Myzar 10.4.5 image to install natively, by intalling the HDD with OSX on as a slave, with the DVD-ROM drive as its master. I am still unable to get OSX to recognise my 2nd IDE disk, but im not fussed for that just yet.

 

My system is:

 

AMD Athlon 64 3200+ (venice)

 

an MSI K8N Neo4-F

 

XFX 6800XT

 

512MB Corsair RAM

 

80GB Maxtor disk, partitioned in 2 (OSX=20GB, and Win MCE05' 55.4GB)

 

System Profiler reports that:

 

IDE is fully functional and working at full speed.

 

Onboard Realtek ALC850 is functional.

 

Firewire is functional (even though not tested)

 

USB 2.0 works.

 

Strangest of all, my processor is reported that its 1000Mhz bus has been slowed to 200MHz, but its clock speed is now 3.2GHz :weight_lift: (when its clocked at 2.01GHz), and also SSE3 is not supported. :thumbsdown_anim:

 

It also belives that there is no network support, even though my motherboard has a Marvell 88E1111 PHY Ethernet chipset embedded. I heard somewhere that this is supported? If somebody could point me in the right direction to get a kext for this it would be greatly apprieciated.

 

jordn

Link to comment
Share on other sites

 Share

×
×
  • Create New...