kadb29 Posted December 30, 2008 Share Posted December 30, 2008 Ok, here are my specs, I'll edit my sig after this. XFX 780i motherboard 6GB PC2-6400 RAM 8800GT 512 MB LG USB DVD Drive IDE DVD drive 500GB SATA HDD drive and an iAtkos v1.0i DVD So when I choose to boot from the USB DVD drive with the DVD in it, I get the Bootloader, but ANY command I enter is met with an instant reboot. I burned at 4x in Nero. Do I need to try another burn? I also have a Kalyway 10.5.2 DVD, but I think it's faulty because it freezes randomly during the installation. Link to comment https://www.insanelymac.com/forum/topic/143565-iatkos-v10i-instant-reboot/ Share on other sites More sharing options...
UnaClocker Posted December 30, 2008 Share Posted December 30, 2008 You do realize that iATKOS is up to version 5 now, right? Why on earth are you using 1? Link to comment https://www.insanelymac.com/forum/topic/143565-iatkos-v10i-instant-reboot/#findComment-1019218 Share on other sites More sharing options...
kadb29 Posted December 30, 2008 Author Share Posted December 30, 2008 Thanks for the reply. Because I found a complete guide for it and that's what I was looking for. I guess I could try getting version 5. But now I have a question about the Kalyway DVD. I disconnected my IDE DVD drive, and it seems to have allowed me to get further with the -v command. But I run into this error "nfs_boot_ init" fail. And sometimes "UIM" unable to initialize. I'm trying to install onto the primary partition on my HDD, so would the command be rd=disk0s2 or s1? And yes, I'm completely new at this, but I figure I'll keep trying on my own until someone responds with a fix. Link to comment https://www.insanelymac.com/forum/topic/143565-iatkos-v10i-instant-reboot/#findComment-1019243 Share on other sites More sharing options...
verdant Posted December 30, 2008 Share Posted December 30, 2008 Thanks for the reply. Because I found a complete guide for it and that's what I was looking for. I guess I could try getting version 5. But now I have a question about the Kalyway DVD. I disconnected my IDE DVD drive, and it seems to have allowed me to get further with the -v command. But I run into this error "nfs_boot_ init" fail. And sometimes "UIM" unable to initialize. I'm trying to install onto the primary partition on my HDD, so would the command be rd=disk0s2 or s1? And yes, I'm completely new at this, but I figure I'll keep trying on my own until someone responds with a fix. Check out my Series 7 nForce chipset + Intel CPU MOBO thread here.......and my blog install guides and other blog entries.......they should help you.......Kalyway 10.5.2 is OK to use as you can update to 10.5.5 using Mysticus C* 10.5.5 Combo Updater packages.......hopefully 10.5.6 a little while later..... Link to comment https://www.insanelymac.com/forum/topic/143565-iatkos-v10i-instant-reboot/#findComment-1019293 Share on other sites More sharing options...
Recommended Posts