Jump to content
5 posts in this topic

Recommended Posts

When I get to select a destination, everything is blank. Shows no hard drive and even no disk utility. Is it not recognizing my HD? I've tried Leo4All and iDeneb with the same result. Any ideas how to get this working?

 

It's currently partitioned with a linux partition as the boot and then Vista on the remaining partition. I was hoping to install OSX 10.5 over Linux....

Link to comment
https://www.insanelymac.com/forum/topic/135082-seagate-320gb-sata-hd-st332082/
Share on other sites

Will it not let you access disk utility either?

 

The partition does not need to be formatted to MacOS Extended Journal BEFORE HAND does it? I would assume it should read my hard drive and bring up the option to use disk utility, but no verison I have tried does.

×
×
  • Create New...