AuxNuke Posted September 4, 2008 Share Posted September 4, 2008 Hello all, first post Just getting into the OSx86 scene here and I can't seem to get any of the normal boot DVD's to work on my rig. The rig is an older Intel build: - Intel i875 board build for Dell - P4 2.4C w/ SSE2 support - 2GB PC-3200 in dual channel mode When booting Darwin from either Kalyway 10.5.2 or Leo4All 10.5.2 (both which support SSE2) it loads the first 10 lines and then promptly reboots the computer. This happens at: "Using ACPI RSDP revision 0 found at 0x000feb90" shown below: Any ideas on how to get around this? Thanks! ~Aux Link to comment Share on other sites More sharing options...
intrax Posted September 5, 2008 Share Posted September 5, 2008 Try to use 'old' ACPI 1.0.3 for SSE2 only rigs. Should do it... Link to comment Share on other sites More sharing options...
AuxNuke Posted September 5, 2008 Author Share Posted September 5, 2008 Try to use 'old' ACPI 1.0.3 for SSE2 only rigs. Should do it...Sure thing! How do I do so? Link to comment Share on other sites More sharing options...
Recommended Posts