Jump to content

final cut studio 2/ FCP 6.0 audio lag issue

sky capt

2 posts in this topic

Recommended Posts



I've had a near perfect experience with my setup until i installed FCP 6.0 recently. Everything loads up fine but i'm encountering 1 major issue. It seems that audio is always out of sync, when i drag the audio file to the preview window the graphic plays through the audio waves but the audio doesn't actually begin until 1-3 seconds into the song. Obviously this makes things a bit difficult. 


My system specs are:


kalyway 10.5.2


Gigabyte GE35C-DS3R, Q6600, nvidia 8800gts 512mb (via chameleon), 4gb corsair ram. 


I'm using Realtek ALC888A drivers patched by pcwiz in an aggregate setup to run 4 channels (stereo 2x/ quadraphonic)


I read elsewhere that i might have to use a bios patch to enable all 4 cores of my processor, however all 4 cores show up in the device utility altho the processor type is listed as 'unkown', i'm not sure if this will effect anything tho.


Anyhow if anyone has any tips, let me know :D

Link to comment
Share on other sites

  • 4 months later...

  • Create New...