motorhead89 Posted August 28, 2008 Share Posted August 28, 2008 Hey, First time poster here....well actually this is my third post and I am looking forward to discussions on this forum. I now have the proper equipment to test this out but it doesn't seem to be working. This is a link to the specific error that I am getting http://imagebucket.info/images/4tkvkp70h7iswq5hioow.jpg. Now this may have been asked and I have looked this up but am not 100% certain on how to go about fixing it. My current build is an Asus P5KPL-CM, 3.0GHZ Core 2 Duo, 500GB Sata Drive and Sata DVD-RW. If anyone could help me it would be this board and I look forward to the response, Thanks a million! Link to comment Share on other sites More sharing options...
motorhead89 Posted August 28, 2008 Author Share Posted August 28, 2008 I still have no idea what I could be doing wrong on this installation so any help would be greatly appreciated. Thanks! Link to comment Share on other sites More sharing options...
teknojunkie Posted August 29, 2008 Share Posted August 29, 2008 what leopard dvd did u use Link to comment Share on other sites More sharing options...
vakakush Posted December 29, 2008 Share Posted December 29, 2008 Hey, First time poster here....well actually this is my third post and I am looking forward to discussions on this forum. I now have the proper equipment to test this out but it doesn't seem to be working. This is a link to the specific error that I am getting http://imagebucket.info/images/4tkvkp70h7iswq5hioow.jpg. Now this may have been asked and I have looked this up but am not 100% certain on how to go about fixing it. My current build is an Asus P5KPL-CM, 3.0GHZ Core 2 Duo, 500GB Sata Drive and Sata DVD-RW. If anyone could help me it would be this board and I look forward to the response, Thanks a million! hi i am unable to open this picture but i think you're getting some error message on boot and your dvd stop to load OS X Leopard, if this is your problem then the solution is:- 1. use sata dvd writer 2. install a nvidia graphic card and do not use on baord graphics. 3. load default settings in your BIOS i have installed ideneb 10.5.4 using same method. good luck :censored2: Link to comment Share on other sites More sharing options...
Recommended Posts