[Inst. Successful] Can't Boot - HSF+ Partition error.

[Jash Sayani]

I successfully Installed Leopard on a COMPAQ Presario M2000 Notebook that I purchased recently. Now, I installed Kalyway on it and I got a b0 error on booting...

After reading some solutions, I did this:

 

Start with the installation disk

At darwin prompt, press F8, then input -v -s and stroke return

now wait for console (the shell #)

when the shell is ready, enter fdisk -e /dev/rdisk0

it will load fdisk, you should see:

fdisk 1>

with a prompt.

Here enter “flag 1″ (without quotes) and then return

then enter “quit” (w/o quotes) and then return

it should says “MBR saved”

now type “exit” (again, w/o quotes) and return

 

 

And now, after reboot, I get the: HFS+ Partition error.

 

Please Help....

[kytzu]

Try this:

 

Here enter “flag 1″ (without quotes) and then return

"update"

"write"

then enter “quit” (w/o quotes) and then return

[Jash Sayani]

Try this:

 

Here enter "flag 1″ (without quotes) and then return

"update"

"write"

then enter "quit" (w/o quotes) and then return

 

Still the same problem....

[Jash Sayani]

I formated the laptop again and installed XP this time in partition 1 and OS X Leopard on partition 2. I booted into xp and added the Chain0 Leopard option in boot.ini

 

But after booting in Leopard, it again shows HSF+ partition error.

[adr1an]

I too am having this issue, only with Vista. I probably followed the same dual booth guide you did I have a couple ideas, so I will run through it real quick and see if it helps. Stay tuned.. (2-3 hours from now)